====================================================================== 
QUICK start INstructions (QUICKIN.DOC)
---------------------------------------------------------------------- 
  Edited 2016 (for personal use) by: James Davis, Beagle Buddy #227.
====================================================================== 

AP2222PC.COM is a .com file that runs in your IBM-PC.
AP2222PC.DSK is the disk image that runs in your Apple II.

To load the whole program to your Apple II:

1. Make the interface cable:
   Connect the lines according to the file, LINECONN.DOC;

2. Boot your Apple II with a 48k DOS 3.3 disk;

3. On your Apple II, type-in the codes from the LOADER.ASM file;

4. Run AP2222PC.COM at your IBM-PC, as follows:

      Type: "AP2222PC.COM -2 AP2222PC.dsk" (No Quotes!)

   Don't press any key when you see "DOIT" on your IBM-PC screen. 
   (Wait for step 6.);

5. Insert a formatted disk into your Apple II disk drive 
   (in Slot-6, Drive-1);

   WARNING!--THE DATA ON THE DISK WILL BE LOST FOREVER!

   Now run the LOADER.ASM code you typed into your Apple II: 

      Type: "300G <Return>" (No Quotes!)

6. Now hit any key on the IBM-PC side to start;

7. You'll hear your Apple II disk drive spinning. 
   Wait until all things stop. 
   Don't hit any key on your IBM-PC or it will quit the program!

8. Check that the checksum on both screens match.

   NOTICE!  

      On the IBM-PC side is a decimal number (it should be 226);
      On the Apple II side is HEX number (it should be E2);

9. Now you can use the whole program.

   Please read the Apple II To IBM-PC instructions (AP2222PC.DOC).

====================================================================== 
